6
SVENSKA
Safety instructions – Reciprocating Saw
Warning: Always unplug the power tool before making adjustments, servicing
or performing maintenance on it.
1. If the power cord becomes damaged it must be replaced at the place of
purchase only.
2. Keep hands away from the blade and other moving parts. Do not reach under
the material being cut. The blade may not be clearly visible.
3. Never place your hand or ngers between the oscillating chuck and the
housing. They may get jammed thereby resulting in injury.
4. Do not cut into walls or other places where hidden electrical wiring may be
present. If you despite this warning must do so: Remove all fuses and turn off
all switches that may be connected to the wiring. Touch only the plastic parts
of the reciprocating saw. Do not touch any metal parts of the reciprocating saw
when cutting where hidden electrical wiring may be present.
5. Do not use dull or damaged blades. Bent blades may easily break or cause
kickback.
6. Start the motor and let it reach full speed before beginning to cut.
7. Fasten small workpieces with clamps, vices etc. before beginning to cut to
avoid bending the blade and to avoid vibrations that may result in losing control
of the reciprocating saw.
8. Make sure that the settings are correct and that the blade is attached properly
before beginning to cut.
To Next Page
Loading...
Need help?
General
