5
9. Advanced Management Settings
9.1) Latch function: On/Off. Default is On.
Fault light will keep flashing if AL3 is activated, indicating unit went into alarm status.
1. Press Up & Enter button for 10 seconds
2. Change to Advance Mode by pressing Mode, and choose Lat Mode
3. Press Up/Down to set Latch Mode On or Off.
4. Press Enter to Save
9.2) Alarm Level Lock: Lock/Unlock.
User cannot adjust the alarm levels when Locked. Default is Lock.
1. Press Up & Enter button for 10 seconds
2. Change to Advance Mode by press Mode, and choose Alm Mode
3. Press Up/Down to set Alm level Lock or Unlk.
4. Press Enter to Save.
9.3) Barometric compensation: On/Off. Default is On.
Unit automatically compensates for barometric pressure / altitude.
1. Press Up & Enter button for 10 seconds
2 Change to Advance Mode by press Mode, and choose Baro Mode
3. Press Up/Down to set Baro Mode On or Off.
4. Press Enter to Save.
To Next Page
