Coaster 205263 - Assembly Tips; Safety Warnings; Parts Identification; Assembly Step 1 & 3

TOP DRAWER
BOTT
OM DRA
WER
COMPLETE
STEP 1
STEP 2
1.1) Unscrew the pull from the back of drawer front.
1.2) Align & fasten the pull to drawer front using screw
and fully tighten with Phillips head screw driver (NOT INCLUDED)
R
FINE FURNITURE
A
DRESSER
1PC
PART NAME
FIGURE
QTY
ASSEMBLY TIME
10 MINUTES
PARTS IDENTIFICATION
ASSEMBLY TIPS:
1 . Remove hardware from box and sort by size.
1 . Don’t attempt to repair or modify parts that are broken or defective. Please contact the
store immediately.
2 . This product is for home use only and not intended for commercial establishments.
2 . Please check to see that all hardware and parts are present prior to start of assembly.
3 . Please follow attached instructions in the same sequence as numbered to assure fast & easy assembly.
!
Warning!
NOTE : PHILLIPS HEAD SCREW DRIVER IS REQUIRED IN THE ASSEMBLY PROCESS;
HOWEVER, MANUFACTURER DOES NOT PROVIDE THIS ITEM.
PAGE 2 OF 3
.www.coastercompany.com
ITEM :
205263
ASSEMBLY INSTRUCTIONS
A
DRESSER
1PC
ASSEMBL
Y
TIME
10 MINUTES
PARTS IDENTIFICATION
P AGE 2 OF 3
COASTERFURNITURE.COM
TOP DRAWER
BOTTOM DRAWER
COMPLETE
STEP 1
STEP 3
ASSEMBLY INSTRUCTIONS
R
COASTER
FINE FURNITURE
ITEM:
205263
WARNING!
1 . Don’t attempt to repair or modify parts that are broken or defective. Please contact the store
immediately.
2 . This product is for home use only and not intended for commercial establishments.
1 . Remove hardware from box and sort by size.
2 . Please check to see that all hardware and parts are present prior to start of assembly.
3 . Please follow attached instructions in the same sequence as numbered to assure fast & easy assembly.
ASSEMBLY TIPS:
STEP 3
NOTE:
Phillips head screw driver is required in the assembly process; however, manufacturer does not provide this item.