What does it mean if calibration wheel is slightly out of balance on Coats Wheel Balancers?
If the calibration wheel is more than 0.25-ounce but less than 1-ounce out of balance on your Coats wheel balancer, the calibration is stored, but with a warning.
What to do if the hood switch is not closed on Coats Wheel Balancers?
If the hood switch is not closed when the machine cycle is started, lower the hood to start the spin cycle and verify the hood switch.
What to do if no load condition is detected on Coats Wheel Balancers?
If no load condition is detected, verify the wheel is mounted properly on the shaft and check repeatability.
What to do if there is no rotation signal on Coats Wheel Balancers?
If there is no rotation signal on your Coats wheel balancer, check the motor, encoder function, and wiring. Then press STOP, then EXIT.
What to do if the encoder is not connected or has failed on Coats Wheel Balancers?
If the encoder is not connected or has failed on your Coats wheel balancer, disconnect the power supply and repair.
What happens if the calibration weight placement exceeds 5 degrees on Coats Wheel Balancers?
If the placement of the calibration weight exceeds a 5-degree range from the outside flange to the inside flange on your Coats wheel balancer, the calibration is rejected.
What happens if the calibration wheel is significantly out of balance on Coats Wheel Balancers?
If the calibration wheel is more than 1-ounce out of balance on your Coats wheel balancer, the calibration is rejected.
Instructions for physically installing and positioning the balancer.
Guidelines for selecting a suitable location and space for the balancer.
Using the laser system for accurate placement of hidden adhesive weights.
Procedure for hiding adhesive weights behind wheel spokes.
Step-by-step guide for calibrating the wheel balancer.
Troubleshooting steps for persistent vibration after balancing.
List and explanation of common error codes and their meanings.
Information on inverter-related errors and conditions.
Explanation of motor overload protection and reset procedures.
General| Brand | Coats |
|---|---|
| Model | Vero V200 |
| Category | Wheel Balancers |
| Language | English |
To Next Page
