CONFIDENTIAL AND PROPRIETARY TO COBHAM
SECTION 1 - INTRODUCTION
IMPORTANT
This manual contains information pertaining to the installation of the C-5000 Communication Management
Controller with FLEXCOMM II and FLEXCOMM I. FLEXCOMM II consists of the RT-5000 Transceiver, appropriate
antennas, and optional equipment as required. FLEXCOMM I consists of the RT-9600 Transceiver, RT-9600F
Transceiver, RT-7200 Transceiver, and optional combinations of up to three of the following FLEXCOMM
Transceivers: RT-30, RT-118, RT-138(F), RT-406F, RT-450, appropriate antennas, and optional equipment as
required. The C-5000 can also interface with combined applications of FLEXCOMM II and FLEXCOMM I, i.e., a
hybrid RT System configuration that consists of both RT-5000 and FLEXCOMM I Transceivers.
1. Components
The following components can be installed:
A. Communication Management Controller
C-5000 PN 31300-0X01-XXXX (See Figure 1-1)
B. FLEXCOMM II
(1) Transceivers
RT-5000 PN 400-015525-XXXX (See Table 1-1)
(2) Antennas Systems (Refer to Table 1-2)
AT-560 PN 121-040130-XX
AT-160 PN 121-040129-XX
AT-5000 PN 121-040045-XX
AT-550 PN 121-017850-01
AT-150 PN 153-017822-01
AT-50 PN 121-016587-01
AT-51 PN 121-016796-01
AT-140 PN 121-016584-01
AT-400 PN 121-16821-01
FC-50 Logic Converter PN 153-016586-01
The document reference is online, please check the correspondence between the online documentation and the printed version.
To Next Page
Need help?
General
