Model Year 2019 page 14
Maverick Boat group, Inc. • 3207 Industrial 29th St. • Fort Pierce, Florida 34946 • (772)- 465- 0631 or (888)- shallow • Fax: (772) 489- 2168
ELECTRIC HEAD OPERATION
Your 301 comes standard with an electric head with 5 gallon holding tank and macerator. See the
diagram on page 16 for a full overview of the sanitation system.
Once you’ve finished using the head, press the flush button
labeled “Elec Head” on the switch panel. This will push the
contents of the head into the holding tank. Note that the
toilet contents will always go into the holding tank first, no
matter if planning on pumping out or using the macerator.
To operate the head, first, make sure that the intake/fill
valve located on the inside of the bottom of the hull
accessed through the hatch to the left side of the toilet (see
diagram) is in the open position. It will be the smaller
diameter of the two valves. The valve is open when its
handle is pointing straight up as shown in the picture to
the left. This will allow water to enter the head upon
flushing.
To evacuate the holding tank via a marina
pump out, make sure that the handle for the Y-
valve located in the access hatch to the right of
the toilet is oriented in the “10 to 5” positon.
This will allow the tank contents to be sucked
out of the tank via the waste deck fitting on the
deck.
To Next Page
Loading...
