Setting Dynamike®
This controls the microphone sensitivity
(outgoing audio level).
To Transmit
To Transmit
Setting
Dynamike
®
Caution!
Be sure the antenna is properly
connected to the radio before
transmitting. Prolonged trans-
mitting without an antenna, or
a poorly matched antenna,
could cause damage to the
transmitter.
Be sure to read the F.C.C. Rules
and Regulations included with
this unit before transmitting.
Operation
Operation
1
Select desired channel.
1
Initially, set fully clockwise so that maxi-
mum voice volume is available. Dynamike®
may have to be reduced in some conditions.
Transmit
Push and hold mic button to transmit.
Transmitter is now activated. When transmit-
ting, hold the microphone two inches from
your mouth and speak in a clear, normal voice.
Release to receive.
1
PUSH &
HOLD
Transmit
RF Meter
RF Meter
This meter swings proportionately to the RF
output (outgoing signal) while transmitting.
To Next Page
Loading...
