Cobra 29 LTD Classic - RF Meter and External Speaker; RF Meter; External Speaker

Operation
12
Note
The reading will be slightly high-
er on Channels 1 and 40 com-
pared to Channel 20.
Note
When switched to SWR position
the meter needle should ideally
be as far to the left as possible.
Anything over 3 is not accept-
able. A slight antenna height
adjustment (higher or lower)
may be required.Repeat relcali-
bration steps.
Repeat the same steps two through five on
Channel 1 and 40.This will check SWR for all
channels.
6
While still holding down the mic button, set
the S/RF SWR CAL switch to the SWR position,
to read the SWR reading.
5
DYNAMIKE
RFGAIN
D
S/RF
SWR
CAL
NB/
ANL
ANL
OFF
CB
PA
B
MIN MAX MIN MAX
SQUELCH
OFF
VOLUME
SIG 1 3 5 7 9 +30dB
2 3 CAL
SWR
RF