Cobra 29 LX BT CB - Transmission and Audio Controls; To Transmit Audio; Setting Dynamike

PUSH &
HOLD
Setting Dynamike®
This controls the microphone sensitivity
(outgoing audio level).
To Transmit
15
To Transmit
14
Setting
Dynamike
®
Caution!
Be sure the antenna is properly
connected to the radio before
transmitting. Prolonged trans-
mitting without an antenna,
or a poorly matched antenna,
could cause damage to the
transmitter.
Be sure to read the F.C.C. Rules
and Regulations included with
this unit before transmitting.
Operation
Operation
3
Select desired channel.
1
Initially, set fully clockwise so that maximum
voice volume is available. Dynamike may
have to be reduced in some conditions.
2
Transmit
Push and hold mic button to transmit.
Transmitter is now activated. When transmit-
ting, hold the microphone two inches from
your mouth and speak in a clear, normal voice.
Release to receive.
SWR/CAL
NB/ANL
VOL SQ DYNAMIKE
OFF MIN
S/RF
M
E
N
U
P
U
S
H
E
N
T
E
R
SIG
RF
+30dB
1
1.5
2
3
CAL
3
5
7
9
SWR
TX
RX
NB/ANL
M
ANL
S/RF
SWR
CAL
R
Setting
TalkBack
Setting TalkBack
This control is used to adjust the desired amount
of modulation talk back is present at the speaker
during transmit.
At fully counter-clockwise position the TalkBack
is Off.
RF GAINDELTA TUNE
T BACK
SWR
CAL
MI
NO
FFMAX
ESC
MEM SCAN
U
P
U
S
H
E
N
T
E
R
MEM WX !
CH
9/
19
CB/WX
DIM
SCAN
29LXBT_MANL.indd 14-15 6/8/12 10:20 AM