OPERATION
ACTIVATING / TESTING SOUNDTRACKER
SOUNDTRACKER SYSTEM
While previous systems only “blanked out” or limited noise in higher
sound frequencies, the revolutionary new SoundTracker System actually
reduces noise while leaving the signal intact in the reception mode. In the
transmission mode, it actually strengthens the signal, providing you with a
significant reduction in noise on reception and transmission.
Sound clarity is measured by the ratio of the signal level
to the noise level. The higher the signal-to-noise ratio, the
better the sound.
HOW SOUNDTRACKER WORKS
On Reception–
“Cuts Noise Coming In”
With a normal CB, distant signals fall below the squelch level and are
unintelligible. With a SoundTracker CB, the noise level is cut by up to
90%, which increases the signal-to-noise ratio and dramatically improves
signal clarity. This also allows you to significantly reduce the squelch
level, which greatly expands your listening range.
On Transmission–
“Strengthens Signals Going Out”
A SoundTracker CB strengthens the transmit signal by more effectively
using the available RF power output of the CB. The result is improved
transmission signal clarity and an expanded transmission range.
11A
10A
OPERATION
HOW SOUNDTRACKER WORKS
ACTIVATING SOUNDTRACKER
1. Switch the SoundTracker toggle to ON
position.
TESTING SOUNDTRACKER
1. Select any unused channel on your CB.
2. Open the squelch fully by turning the knob
counter-clockwise until it stops.
3. Turn the volume up louder than your
normal listening level.
4. Switch the SoundTracker toggle off and on.
Notice the significant reduction in noise.
To Next Page
Loading...
Need help?
General
