Cobra 4698 - User Manual

“QUICK REFERENCE” USER MANUAL 4693-4698
“QUICK REFERENCE” USER MANUAL 4693-4698
4
06DE3798A - 02/13
5. - WARRANTY CONDITIONS
This product is guaranteed for 24 months from the date of purchase, validated by receipt or invoice. The warranty will be null and
void if the product shows signs of tampering, incorrect installation, damage caused by falling or transport, negligence and anything
else not imputable to manufacturing defects.
In the event of improper installation of the system, the manufacturer shall not be liable to compensate for damages:
- of any kind and direct or indirect;
- to things or to persons.
To benefi t from warranty coverage, contact your authorized dealer with adequate documentation showing the date of purchase.
The manufacturer shall not be liable for any faults or malfunctions in the anti-theft device and/or in the electrical system of the
vehicle due to incorrect installation and/or to failure to comply with the indicated technical specifi cations. The system must only be
considered as a deterrent agaist theft attempts.
6. - DECLARATION OF CONFORMITY
Cobra Automotive Technologies
CAT-VA
Declaration of Conformity
The manufacturer hereby declares, at its sole responsibility, that the product:
Description: Wireless alarm system for automotive application
Model: 4600
Type: 4600 family with siren type 5365
is in conformity with the essential requirements of the R&TTE Directive 1999/5/EC.
The product has been tested against the following standards and specifications:
EMC : ECER10
Health and Safety: Relevant tests of ECER116 Regulation
EN50371
Radio Spectrum: EN 300 220-1
EN 300 220-2
and declares that the:
TRANSMITTER Model 2781 and Model 7777
conform to the essential requirements of the Radio and Telecommunication Terminal Equipment
Directive 1999/5/EC in accordance to the following relevant standards and Directives:
Radio: EN 300 220-1/2
EMC: EN 301 489-1/3
Health & Safety: EN 60950
EN 50371
The products are marked with the following CE marking and Notified Body number according to the
Directive 1999/5/EC:
2010-09-22
Dario Parisi
Products Homologation Engineer
Tel +39 0332 825111
4693-4698 “QUICK REFERENCE” USER MANUAL
1
4693-4698 “QUICK REFERENCE” USER MANUAL
1. - ARMING AND DISARMING OF THE SYSTEM
To arm the system press the “A” pushbutton of the remote control.
The arming status is confi rmed by:
• Vehicle doors locking;
• Audible signals (if activated);
• Flashes of the direction lights;
• LED of the emergency panel illuminated.
The protection features of the system become active after a 25 s arming period has elapsed (when
the LED of the emergency panel starts blinking).
To disarm the system press the “B” pushbutton of the remote control.
The disarming status is confi rmed by:
• Vehicle doors unlocking;
• Audible signals (if activated);
• Flashes of the direction lights;
• LED of the emergency panel OFF.
Note: if also the Driver Card (optional) is provided it will be also possible to arm and disarm
the system by pressing its pushbutton.
The system is delivered with a set of standard functionalities (active functions). The installer is able to activate some more
functionalities (programmable functions) with an impact on the security and comfort the system will offer. The following are the
lists of the two groups.
2. - ACTIVE FUNCTIONS
2.1 - Interior protection with ultrasonic volumetric sensor - The system protects the vehicle interior with a volumetric ultrasonic
sensor. Any attempt to get into the vehicle will be detected and the alarm will trigger.
2.2 - Perimetric protection with door open warning diagnostic - The alarm will trigger by opening any door, boot and bonnet.
Should you have left any door opened while arming, the system will signal it by 3 fl ashes of the direction lights and 3 audible signals
(5 audible signals if the arming/disarming audible signals function has been activated).
2.3 - Cable cutting protection (only for systems with back-up battery siren) - The alarm will trigger if the system is not power
supplied (cutting of cables - battery disconnection) signaling the sabotage.
2.4 - Engine starting inhibition - As soon as the system is armed the engine starting is not be possible anymore.
2.5 - Arming the system with the volumetric ultrasonic protection disabled - This function allows to arm the system leaving
temporarily disconnected the interior volumetric protection. The protection must be disabled any time you leave somebody or an
animal in the vehicle. Also if you want to leave any window opened please disable the protection to avoid false alarms. All other
protections remain active.
Button A >
to arm the alarm and to
lock doors.
B
A
Button B >
to disarm the alarm and to
unlock doors.
B
A
THE FULL USER MANUAL IS AVAILABLE ON-SITE WWW.COBRA AT.COM AT LINK “DOWNLOAD USER
MANUAL”.

Summary

Warranty Conditions

Declaration of Conformity

Arming and Disarming the System

Arming the System

Press 'A' pushbutton to arm. Confirmed by vehicle lock, sounds, lights, LED.

Disarming the System

Press 'B' pushbutton to disarm. Confirmed by unlock, sounds, lights, LED OFF.

Active Functions

Interior Volumetric Protection

Uses ultrasonic sensor to detect interior intrusion and trigger alarm.

Perimetric Protection

Triggers alarm on opening any door, boot, or bonnet while armed.

Cable Cutting Protection

Triggers alarm if system loses power (cable cut, battery disconnect).

Engine Starting Inhibition

Prevents the engine from starting once the system is armed.

Arming with Volumetric Protection Disabled

Allows arming with interior protection temporarily off for occupants or open windows.

Programmable Functions

Passive Arming

System arms automatically 30s after ignition off and driver door closed.

Auto Re-arming

System re-arms automatically if disarmed and no door opened within 115s.

Auto Re-arming with Doors Locking

Similar to auto re-arming, but also locks the vehicle doors.

Passive Engine Starting Inhibition

Starting inhibition activates 115s after ignition OFF, deactivated by Driver Card or PIN.

Comfort Window Closing

Allows remote closing of vehicle windows by holding the 'A' pushbutton.

Emergency Override with PIN Code

Emergency Disarming Procedure

Steps to disarm the system if the remote control is lost or malfunctioning.

Anti Hi-jacking

Manual Driver Recognition

Driver recognized by entering first two PIN digits on the emergency panel.

Automatic Driver Recognition

Driver recognized automatically when the Driver Card is detected.

Garage Mode

Temporarily disables automatic protection functions for maintenance purposes.

Cobra 4698 Specifications

General

Brand	Cobra
Model	4698
Category	Security System
Language	English