Cobra 75 WX ST - Remote Mount Installation

8
INSTALLING THE REMOTE MOUNT
1. Hold the Cobra 75WXST Remote Mount
in exact location desired for mounting.
2. Using it as a template, mark the location
for the mounting screws (included).
NOTE: Make certain that nothing will
interfere with the installation of the
mounting screws, before drilling holes.
3. Drill and mount the Remote Mount
as shown.
CONNECTING WIRES
4. Connect the antenna cable plug.
5. Connect the red wire directly to the
positive side of the battery or to a
connection on the fuse box that is
always on.
Connect the black wire to the negative
side of the car, usually the chassis. Any
other location with good electrical contact
(paint removed) will also work.
6. For dash installation of the remote
mount connector , mount the plate and
grommet kit in a convenient location
that will not interfere with the operation
of the vehicle.