11
Part 5 Cleaning and Maintenance
CORRECT LEVEL FOR FRYING MEDIUM WHEN AT
FRYING TEMPERATURE, KEEP TOPPED UP
INDICATES CORRECT FRYING MEDIUM LEVEL
WHEN COLD
Draining and Cleaning
Opening the Drain Valve
a. Lift the locking slide on valve handle (Fig 1) to
release valve.
b. While holding the locking slide in the
withdrawn position, rotate the handle
anti-clockwise (Fig 2) to open the valve.
c. When the valve is closed, the locking slide will
drop down over the locking valve to prevent
accidental opening of the valve as shown in
Fig 2.
Daily Cleaning
1. At the end of each day / shift, if frying schedule
is heavy, frying medium should be drained and
strained into a receptacle.
2. Screw on the drain extension pipe and position a
suitable container and filter under the drain.
3. Slip a muslin or other suitable bag over the drain
valve. Crumbs will be caught in the bag but
frying medium will strain freely through bag into
the receptacle.
General
To achieve the best results cleaning must be
regular and thorough and all controls and
mechanical parts checked and adjusted
periodically by a qualified service person. If any
small faults occur, have them attended to
promptly.
Don't wait until they cause a complete
breakdown. It is recommended that the
appliance is serviced every 6 months.
Clean the fryer regularly. A clean fryer looks
better, will last longer and will perform better.
NOTE:
DO NOT use abrasive detergents, sharp scrapers,
strong solvents or caustic detergents as they
could corrode or damage the fryer.
Ensure that any detergent or cleaning material
have been completely removed after each
cleaning.
To keep your fryer clean and operating at peak
efficiency, follow the following procedures:-
C
AUTION
:
Always turn off the gas supply at the mains
supply before cleaning.
This appliance is not water proof.
Do not use water jet spray to clean interior
or exterior of this appliance.
WARNING:
DO NOT
USE FLAMMIBLE SOLVENTS AND CLEANING AIDS ON
OR IN CLOSE PROXIMITY TO THE FRYER WHILST THE FRYER IS STILL
HOT.
C
AUTION
:
Never drain the fryer with power or burner
‘ON’
Always switch ‘OFF’ the fryer before draining
or re-filling the tank.
WARNING:
DO NOT ATTEMPT TO MOVE THE FRYER WHILST THE FRYER IS FULL
OF OIL.
BEFORE
ATTEMPTING
TO
MOVE
THE
FRYER
,
ENSURE
THAT
ALL
THE
OIL
HAS
BEEN
DRAINED
FROM
THE
TANK
.
REFER
TO
THE
INFORMATION
BELOW
ON
HOW
TO
DRAIN
THE
OIL
FROM
THE
FRYER
.
Fig 1
Locking
Slide
WARNING:
HOT OIL WILL BURN - DO NOT RUSH THIS JOB.
Fig 2
Locking
Slide
To Next Page
Loading...