Cobra HH34 - Operating Your Cobra HH 34; Antenna and Battery Installation

To remove belt clip,
lift tab out and slide
belt clip down.
1
2
Slide belt clip up on
rails of base until
tab locks.
OperationOperation
Attach Antenna
32
Attach Antenna
Insert.
Attach Belt Clip
1
Turn clockwise.
2
Remove battery chamber cover.
Install batteries by polarity markings.
Replace cover.
Battery
Installation
Install Batteries
1
2
3
Note
Ignoring polarity markings can
cause damage to both the unit
and the batteries.
The HH 34 requires 9 “AA”
alkaline or NiCad batteries
(not included with the unit).
When batteries are low or need
charging the TX/Batt LED will
remain on.Replace alkaline
batteries or recharge NiCad
batteries.
hh 34 manual layout.4 10/1/98 10:04 AM Page 8