12
Push the hedge trimmer into the long reach shaft
as shown. Check the hedge trimmer is securely
locked in place.
The long reach attachment is
articulating to suit the working
angle and hedge position.
Squeeze both sides of the
articulating joint to release the lock
and adjust the angle as required.
Caution: Wear gloves and hold
the attachment whilst pressing
the release button. Do not hold
the blades.
Starting the Long Reach Hedge
Trimmer
Fit the battery and switch on the
tool, pressing the safety power
button as per the previous section.
To start the cutting blades
operating, press the lock button
followed the trigger button. Hold
the attachment handle and the
lower handle.
Release the trigger button to stop
the blades.
To Next Page
Loading...
