Cobra MicroTalk 2 FRS 110 - Battery Installation; Turning on; Illuminating the Display

Push and hold the POWER button for
2 seconds. An audible “tone” will indicate the
unit is on.
Operation
3
Turning On Your microTALK®
Note
Whenever the unit is on
you can receive
communications.
Turning
On Your
microTALK
®
Illuminating the Display
Illuminating
the Display
1
1
Push and release LIGHT/MAX RANGE
button to illuminate display for ten seconds.
Pull lock tab down
to remove battery
cover.
Insert four “AAA”
batteries. Position
batteries according
to polarity markings.
Operation
2
Note
Always use high quality
alcaline batteries.
When batteries are low the
indicator will blink.
Install Batteries
Battery
Installation
1 2
--++
++
--