2
Power Saver
DCS WX
VOX Low
CTCSS
Product Features
1
3
7
11
8
4
5
12
13
14
15
10
6
9
1. Antenna
2. External Speaker/
Microphone/Charge Jack
3. Mode/Power Button
4. Lock Button
5. Channel Up/Down Buttons
6. Backlit LCD Display
7 Speaker/Microphone
8. Volume Up/Down Buttons
9. Light/Max Range Button
10. Talk Button
11. Call Button
12. Wrist Strap Connection
13. Belt Clip
14. Battery Compartment
15. Battery Door Latch
Product Features
Introduction
Product Features
Features
• 22 Channels
Seven shared
with FRS/GMRS,
seven FRS only,
eight GMRS only.
• 10 Channel NOAA All
Hazards Radio
• Weather Alert
• 121 Privacy Codes
(38 CTCSS codes/
83 DCS codes)
• Hands-Free Operation
(VOX)
• Scan
Channels,
privacy codes
• Backlit LCD Display
• Call Alert
Five selectable
tones
• Button Lock
• Speaker/
Microphone/
Charge Jack
• Roger Beep
Selectable On/Off
• Battery/Power Saver
• Keystroke Tones
• Battery Low Indicato
• Auto Squelch
• Maximum
Range Extender
• Belt Clip
Introduction
Backlit LCD Display
1. Battery Low Indicator
2. VOX Icon
3. Scan Icon
4. Roger Beep Icon
5. Lock Icon
6. Low Power Icon
7. DCS/CTCSS Icons
8. Weather Icon
9. Weather Alert Icon
10. DCS/CTCSS Privacy Code Numbers
11. Power Saver Icon
12. Channel Numbers
13. Receive/Transmit Icon
1
2
3
4
5
6
11
12
13
10
8
7
9
Remove Belt Clip
PullUp Lock Latch
Insert Batteries
Operation Customer Assistance Warranty
Introduction
Caring for Your microTALK
®
Radio
•
Your microTAL
K
®
radio will give you years of trouble-free service
if cared for properly. Handle the radio gently.
K
eep the radio away
from dust. Never put the radio in water or in a damp place. Avoid
exposure to extreme temperatures.
Installing
b
atteries
•
To install or replace batteries:
1. Remove belt clip by releasing belt clip
latch and sliding clip up.
2. Pull up on the battery door latch to remove the
battery compartment cover.
3. Insert the supplied four AAA rechargeable
batteries or non-rechargeable alkaline batteries.
Position batteries according to polarity
markings.
4. Replace battery compartment cover and
belt clip.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable (Ni-Cd, Ni-MH, etc.) batteries.
To charge batteries in radio:
1. Check to see that the batteries have been
inserted properly.
2. Insert the wall charger/adapter into the charge
jack located at the top of the radio.
3. Plug the wall charger/adapter into electrical
outlet.
Use only the supplied rechargeable batteries and charger for
recharging your Cobra microTAL
K
radio.
Cobra recommends your radio is turned off while being charged.
Non-rechargeable alkaline batteries can also be used in your radio.
Radio Charger Jack
To Next Page
Loading...
Need help?
General
