Remove Belt Clip
Pull Up Lock Latch
Insert Batteries
Operation Customer Assistance Warranty
Introduction
Caring for Your microTALK
®
Radio
•
Your microTALK
®
radio will give you years of trouble-free service
if cared for properly. Handle the radio gently. Keep the radio away from
dust. Never put the radio in water or in a damp place. Avoid exposure to
extreme temperatures.
Rechargeable Batteries and Desktop Charger
•
To install or replace batteries:
1.
Remove belt clip by releasing belt clip
latch and sliding clip up.
2.
Pull up on the battery door latch to remove the
battery compartment cover.
3.
Insert the supplied four AAA rechargeable
batteries or non-rechargeable alkaline batteries.
Position batteries according to polarity markings.
4.
Replace battery compartment cover and
belt clip.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable (Ni-Cd, Ni-MH, etc.) batteries.
To charge radios in desktop charger:
1. Insert radio(s) into desktop charger as shown.
2. Insert round connector of 120-volt adapter into
jack on back of charger.
3. Plug 120-volt adapter into electrical outlet.
If charging light is not on, check position of radio.
Radio should be upright. The charge indicator light
will stay on as long as the radio is in the charging
well, even after the batteries are fully charged.
It normally takes about 15 hours to fully recharge
batteries. Batteries will not be damaged if they stay
in the charging well longer than that.
1
Nothing Comes Close to a Cobra
®
Insert radio(s)
CXT280_MANL_vB.indd 1 5/16/13 4:08 PM
To Next Page
Loading...
Need help?
General
