Introduction
Caring for Your microTALK
®
Radio
•
Your microTALK
®
radio will give you years of trouble-free service
if cared for properly. Handle the radio gently. Keep the radio away
from dust. Never put the radio in water or in a damp place.
Avoid exposure to extreme temperatures.
Batteries
•
To install or replace batteries:
1. Remove belt clip by releasing belt clip
latch and sliding clip up.
2. Pull up on the battery door latch to
remove the battery compartment cover.
3. Insert four AAA batteries. (Always use
high quality alkaline batteries.) Position
batteries according to polarity markings.
4. Replace battery compartment cover and
belt clip.
Contact your local Cobra dealer or Cobradirectly
for optional accessories. Only Cobra authorized
accessories are recommended.
Insert Batteries
Pull Up Lock Latch
Remove Belt Clip
The Basics to Get You Started
Your microTALK
®
radio is easy to use.
To get started, simply:
1. Press and hold the Mode/Power button
to turn
on your radio.
2. Press the Channel Up or Channel Down
button to select a channel.
Both radios must be tuned to the
same channel to communicate.
3. Press and hold the Talk button while
speaking into the microphone.
4. When finished talking, release the Talk
button and listen for a response.
To Next Page
Loading...
Need help?
General
