To Next PageTo Next PageWhy my Cobra Transceiver unit does not turn on?
If your Cobra Transceiver unit doesn't turn on, the issue might stem from a defective power switch VR3 or a defective regulator U8. Start by checking the battery voltage.
What to do if my Cobra Transceiver has no transmit (TX)?
If your Cobra Transceiver has no transmit (TX), it could be due to a defective PTT switch or a defective regulator U8. Also, check TP1 voltage; it should be between 0.5 and 4V. Inspect the power transmits circuit Q12, Q6, D1, D2, and Q1, as well as the power control circuits Q17, Q18, Q24 and U2.
Why is the receiver sensitivity low on my Cobra MR HH330 FLT?
If your Cobra Transceiver exhibits low receiver sensitivity, inspect the antenna and connector for any signs of corrosion or a poor connection. Check the output level of local OSC, as the failure of the output from Q7, Q8, Q2, U1 may be the cause.
What to do if my Cobra Transceiver has no receive (RX)?
If your Cobra Transceiver has no receive (RX), the issue could be a defective regulator U8, Q7, Q8, Q2, F1 and F2. Verify the voltage at TP1, which should be between 0.5 and 4V. Also, check the second OSC at 20.95MHz, pin 9 of U6, and the U1 audio output voltage at pin 9.
How to troubleshoot low RF power output on a Cobra Transceiver?
If your Cobra Transceiver has low RF power output, check the RF power output from Q6. If it's good, inspect the antenna switching diodes D1 and D2. If it's not good, check the voltage level outputs of the drive amplifiers Q3 and Q12, along with their associated circuitry.
Why is the squelch circuit inoperative on my Cobra MR HH330 FLT?
If the Cobra Transceiver's squelch circuit is inoperative, check the squelch control. The issue may also be related to a defective U1 or associated circuitry between pins 9, 10, and 11.
Why is there poor or no modulation on my Cobra MR HH330 FLT Transceiver?
If your Cobra Transceiver has poor or no modulation, the issue might be a defective microphone or a defective U4 and/or its associated components.
What causes deviation of transmit frequency in my Cobra MR HH330 FLT Transceiver?
If the transmit frequency of your Cobra Transceiver is deviating, check the crystal X2 and VC1.
General| Frequency Range | 156.050 - 163.275 MHz |
|---|---|
| Battery Life | Up to 12 hours |
| Waterproof Rating | IPX7 |
| Power Output | 6 Watts |
| Number of Channels | All USA, International & Canadian Channels |
| Battery Type | Rechargeable Lithium-Ion |
| Type | Handheld VHF Marine Radio |
Detailed specifications for the VHF receiver section.
Detailed specifications for the transmitter section.
Explanation of the radio's transmitter circuit and functionality.
Explanation of the radio's receiver circuit and functionality.
Detailed list of components on the main PCB for US version.
Voltage chart for the BA4116FV IC under Tx and Rx modes.
