17
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Caution Warning
Installation
Customer
Assistance
Introduction
Nothing Comes Close to a Cobra
®
16
English
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Caution Warning
Installation
Customer
Assistance
Introduction
Included in this Package
Included in this Package
•
You should nd all of the following items in the package with
your Cobra VHF/GMRS radio:
MEMSAMEVOX HI
ROG
VHF
GMRS
T
R
X
U
Radio Drop-In Battery Charger
DC Charger
For connection to 12-volt power
sources.
LiON Battery Pack
Operating Instruction Manual Spring-Loaded Belt Clip
Antenna
AC Charger
For connection to 120-volt power
source.
Wrist Strap
Alkaline Battery Tray
Install/Remove Antenna
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Caution Warning
Installation
Customer
Assistance
Install/Remove Antenna
•
1. To install the antenna turn the antenna into the radio
clockwise to tighten. Do not overtighten.
2. To remove the antenna turn the antenna counterclockwise.
This radio transmitter IC: 906A-MRHH450 has been approved
by Industry Canada to operate with the supplied antenna. Other
antennas are strictly prohibited for use with this device.
Cet émetteur radio IC: 906A-MRHH450 a été approuvé par
Industrie Canada pour fonctionner avec l’antenne fournie.
D’autres antennes sont strictement interdits pour une utilisation
avec cet appareil.
Batteries and Charger
•
The radio is shipped with a sealed lithium-ion (LiON) battery pack
(P/N CM 110-026) that is rechargeable.
WARNING
The charger provided for this radio is only to be used
to charge the battery pack provided. Do not charge any
other type of batteries in the charger as fire, explosion
or battery damage will occur. Avoiding extreme
temperatures will also help prolong the life of the battery
pack for the radio.
When your rechargeable batteries begin to discharge too quickly,
it is time to install a new battery pack. Your radio
will also operate with five (5) high-quality AA alkaline batteries,
using the included alkaline battery tray.
Installing the Battery Pack
1. Position the battery pack over the back of the radio.
2. Engage the battery pack into the radio by sliding to the top
until battery pack is fully seated against radio housing.
3. Tighten the screw using the end of the belt clip to secure the
battery pack to the radio. Do not overtighten. Only use the end
of the belt clip to tighten the screw.
Antenna
Install Battery Pack
LiON Battery Pack
Tighten Screw
To Next Page
Loading...
Need help?
General
