EasyManuals Logo

Cobra MT250C User Manual

Cobra MT250C
47 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #43 background imageLoading...
Page #43 background image
Installing the Hedge Trimmer Cutter Assembly
The cutter blades are very sharp. Do
not handle the cutter assembly unless
the protective blade cover is in place.
IMPORTANT
WARNING!
Always wear gloves when working with or
near the cutter assembly.
1.
Remove the output shaft from the rubber
sleeve.
2.Insert the output shaft into the gearbox, align
the hexagonal screws and then tighten on
both sides, as shown in the illustration.
3.
Working head rotation:
Only change the position of the head when
the engine is not operating.
1. Pull back the lock collar as shown in the
illustration.
2. Select the required working angle for the
hedge trimmer head, rotating the side
lever.
42
4.
Gearbox Grease
1. After 25 hours run time, grease the
gearbox.
2. Use an injection pump at the designated
gearbox nozzle points, as shown.
3. Gearbox grease recommended:
OEST LT200EP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cobra MT250C and is the answer not in the manual?

Cobra MT250C Specifications

General IconGeneral
BrandCobra
ModelMT250C
CategoryTrimmer
LanguageEnglish

Related product manuals