What causes Cobra MX484SPCE engine to skip at high speed?
If the Cobra Lawn Mower engine skips at high speed, the gap between the spark plug electrodes may be too close. Set the gap between the electrodes at 0.7 to 0.8mm.
Why won't my Cobra MX484SPCE Lawn Mower engine start?
If your Cobra Lawn Mower engine won't start, several factors could be at play. First, ensure the throttle choke is correctly positioned for the current conditions. If the fuel tank is empty, refill it, consulting the ENGINE OWNERS MANUAL for guidance. Check the air cleaner element and clean it if dirty, again referring to the ENGINE OWNERS MANUAL. Make sure the spark plug is tightened to 25-30Nm and that the spark plug wire is securely connected. Verify the spark plug gap is between 0.7 and 0.8mm. If the spark plug is defective, replace it with a new, correctly gapped one, as detailed in the ENGINE OWNERS MANUAL. If the carburetor is flooded, remove the air cleaner element and pull the starter rope until it clears, then reinstall the element. Finally, if you suspect a faulty ignition modul...
Why Cobra MX484SPCE engine does not start?
If your Cobra Lawn Mower engine won't start, several factors could be at play. The throttle choke might not be correctly positioned; adjust it accordingly. The fuel tank could be empty, so fill it, referring to the ENGINE OWNERS MANUAL. A dirty air cleaner element could be the culprit, so clean it, referring to the ENGINE OWNERS MANUAL. Check the spark plug: if it's loose, tighten it to 25-30Nm. Ensure the spark plug wire is securely connected. The spark plug gap might be incorrect; set it between 0.7 to 0.8mm. If the spark plug is defective, replace it with a new, correctly gapped one, referring to the ENGINE OWNERS MANUAL. If the carburettor is flooded, remove the air cleaner element and pull the starter rope until it clears, then reinstall the element. If none of these work, the ignitio...
Pre-operation checks, fluid levels, and safety precautions.
Procedures for starting the engine and engaging the cutting blade.
Guidelines for safe and effective operation during use.
Instructions on how to safely shut down the engine and blade.
Steps for sharpening, balancing, and replacing the cutting blade.
Pre-operation checks, fluid levels, and safety precautions.
Procedures for starting the engine and engaging the cutting blade.
Guidelines for safe and effective operation during use.
Instructions on how to safely shut down the engine and blade.
Steps for sharpening, balancing, and replacing the cutting blade.
General| Power Source | Petrol |
|---|---|
| Engine | Cobra |
| Engine Type | 4-Stroke |
| Cutting Width | 48 cm |
| Cutting Heights | 25 - 75 mm |
| Drive Type | Self Propelled |
| Mulching | Yes |
| Side Discharge | Yes |
| Warranty | 2 Years |
| Collection Capacity | 60 L |
| Wheel Size | Rear: 10 inch |
To Next Page
