Why Cobra 400W Lawn Mower does not start?
Your Cobra Lawn Mower might not start because it is not connected to the power supply. Ensure it is properly connected. Alternatively, there may be a loose power connection or another electrical defect. In such cases, it is best to check with a Cobra dealer.
What to do if my Cobra 400W Lawn Mower does not reach full power?
If your Cobra Lawn Mower isn't reaching full power, the extension cord might not be suitable for operating the mower. Try using a proper extension cord. Another reason could be that the power source has too low voltage; in that case, connect to another power source. If the mower's internal wiring is damaged, contact a Cobra dealer.
Why Cobra Lawn Mower cutting blades not rotating?
If the cutting blades on your Cobra Lawn Mower aren't rotating, it could be because the blades are obstructed. Clear any obstruction that you find. It is also possible that the belt is slipping or damaged, in which case you should contact a Cobra dealer.
What to do if Cobra Lawn Mower is not cutting?
If your Cobra Lawn Mower is not cutting, it might be because the height of the cut is too low. Increase the cutting height. Alternatively, the blades may be off cut and require adjustment.
Why Cobra Lawn Mower has excessive vibration or noise?
Excessive vibration or noise in your Cobra Lawn Mower could be due to damaged cutting blades, in which case, contact a Cobra dealer. Another possibility is that the cutting blades are not adjusted evenly and require adjustment.
Why Cobra Lawn Mower leaves a ragged finish?
If your Cobra Lawn Mower is leaving a ragged finish, it's likely that the cutting blades are off cut and require adjustment.
Why Cobra 400W rollers do not rotate?
If the rollers on your Cobra Lawn Mower do not rotate, it's probably because the roller is blocked by debris. Clean all roller slots to resolve this.
General| Brand | Cobra |
|---|---|
| Model | 400W |
| Category | Lawn Mower |
| Language | English |
Guides the assembly of the lower handle to the mower body.
Details the connection of middle and upper handle sections.
Instructions for attaching cable clips and the grass collection bag.
Essential safety checks and precautions before powering the mower.
Steps for adjusting the mower's cutting height to three positions.
Instructions for using the safety switch and adjusting the cutting cylinder.
Guidance on positioning and managing the power cord while mowing.
How to use the integrated system for managing the mower's power cable.
Instructions for folding handles and storing the mower safely.
Guidelines for safely transporting the lawn mower.
To Next Page
