- 9 -
5.5 BEFORE CONNECTING TO THE POWER SUPPLY
WARNING: READ ALL THE INSTRUCTIONS BEFORE PROCEEDING
1. Never use the mower if the power cable is damaged or cut in anyway. Replace the cable before using.
2. Do not use the use the mower in damp conditions.
3. Use a Residual Current Device (RCD) as a safety precaution.
4. Only extension cables suitable for outside use should be used. Always fully unwind the cable fully, coiled
cables may overheat and reduce the efficiency of the mower.
5. The cross section of the wire of the extension cable must 1.5mm or greater for cables up to 15m in length.
Where the extension cable is 15m to 40m long ensure the wire diameter is 2.5mm or more.
6. The power rating of the mower is 230-240 VAC 50Hz. The plug is fitted with a 13amp fuse.
Fitting the cable clip:
1. Ensure the mower cable is not powered before proceeding.
2. Fold the cable to form a loop and then pass the loop through the large slot as
shown opposite, such that the cable hooks over the middle peg.
3. The cable clip is designed to protect the connection in the switch box.
6. OPERATING THE MOWER
WARNING: ALWAYS UNPLUG THE MOWER BEFORE UNDERTAKING ANY ADJUSTMENTS TO THE
MOWER. WEAR SAFETY GLOVES WHEN WORKING MAINTAINING THE MOWER.
6.1 CHANGING THE CUTTING HEIGHT
1. The mower has 3 heights of cut. Position 3 is the lowest height of cut, which is 18mm. The highest height of
cut is 38mm and the middle position is 28mm.
2. To change the height of cut pull the lever outward away from the mower and then move the lever to the side
to select the required cutting height. Release the lever gently to lock the position.
To Next Page
Loading...
Need help?
General
