Cobra ODE - Page 43

Cobra ODE User Manual v2.0
36
iso.INT.path=
If the manager is in custom or custom+homebrew mode with the
manager.type=customonfiguration option, then this option can be used to
define the path to the iso when the associated iso.INT.sector configuration option is
triggered. The INT value must be a base 10 integer lower than 500 and determines the iso
index. The path is not case-sensitive, and path separator is the '/' character. The path has a
limit of 128 characters. If this option is not set, then it will default to
/PS3_GAMES/game.iso.
eject.sector=HEX
If the manager is in custom or custom+homebrew mode with the
manager.type=custom configuration option, then this option can be used to define
the sector that triggers the disc's auto-eject feature. The HEX value must be a hexadecimal
value representing the sector number to act as a trigger. If the eject is triggered, by reading
of that sector, then the ODE will emulate a disc ejection and reinsertion automatically.
eject.on_selection=0
If set, the ODE will automatically trigger the auto-eject feature as soon as a game selection
has been triggered.
Any value other than '0' will default back to the behavior or switching to manager mode on
disc eject only. By default the option is enabled.
hdd.poll=INT
If set, the ODE will poll the hard drive every INT minutes to prevent the HDD from going
idle and entering sleep mode.The INT value must be a base 10 integer. If the value is set to
0, then HDD polling is disabled. If a value is not set, then HDD polling value defaults to
'1'.