Cobra Power Station 200W User Manual

Connecting Devices to the Power Station
6
The power station is divided into different power sections depending on the type of connection your
devices requires. To properly connect and power/recharge a device with the power station, follow
these steps.
1. Determine the connection type required for your device (AC Outlet, USB-A, USB-C,
12V DC).
2. Press the switch associated with the power section you are looking to use in order to
activate that section.
3. Plug in your desired devices.
Using the Power Inverter
The power station is equipped with an internal 200W pure sine wave inverter, which allows you to
connect devices to the two AC outlets just like you would at your home. However, there is a limit to
how much power the power station can continuously output (200 Watts). If the output power to the
AC outlets exceeds that limit for an extended period, the inverter
will shutdown in order to protect from damaging itself or the
power station.
• To see how much power your power station is currently
outputting, look at the “Output” power value located on your
power station’s LCD screen.
• Additionally, as a quick check to see what your device’s
power requirements are, multiply the expected current draw
of your product by 110 to see what the expected power draw
will be in Watts (W).
• When using the power station’s inverter, the internal cooling fan will turn on once a certain
temperature is detected. This will continue to run as long as the inverter is operating in order to
cool internal components. Once the inverter has stopped being used or the 110V
switch has been turned off, the fan will turn off.
Using the Power Station’s Flashlights
LED Flashlight
• To turn on the LED ashlight, press and release the LIGHT
button on the control panel. After the ashlight has been on for
more than two seconds, press and release the LIGHT button
again to turn the LED ashlight off.
• To cycle between the three modes on the LED ashlight (solid,
strobe, SOS), after turning on the ashlight, press and release
the LIGHT button to cycle between each mode until the desired
mode is selected.
Area Light
• To turn on the area light, press and hold the LIGHT button on the control panel until the area light
turns on. To turn off this light press and hold the LIGHT button until the area light turns off.
W
W
USB 12V
INPUT
OUTPUT
W
W
USB 12V
INPUT
OUTPUT

Cobra Power Station 200W Specifications

General

Brand	Cobra
Model	Power Station 200W
Category	Power Supply
Language	English