cuttings, you will need to empty and clean the grass catcher.
1. Stop the engine and wait until it comes to a stop.
2. Lift the deflector flap and unhook the grass catcher. (Fig.9B)
3. Empty out the contents.
Fig.9A Fig.9B
6.4 HEIGHT ADJUSTMENT INSTRUCTIONS
CAUTION: Do not at any time make any adjustment to scarifier without first stopping the engine.
Your scarifier is equipped with a depth adjustment lever offering a range of working positions. The working
positions are -3mm, -6mm, -9mm, -12mm, -15mm height.
1. Stop the scarifier and disconnect spark plug cable before changing scarifier cutting height.
2. To change the height of cut by turning the front knob clockwise rotation or counter clockwise to the required
height.
3. Move the transport lever to transport position to prevent cutter deck from touching the ground after finishing
the work.
Fig.10A Fig.10B
7. REPLACEMENT OF THE SPRING TINE & AERATOR
WARNING: Be sure to wear work gloves. Switch off the engine.
Caution: use only original scarifier/aerator shafts approved by the manufacturer.
The equipment can be assembled with the scarifying roller or the aerator roller.
To Next Page
Loading...