5.5 DEPTH OF CUT
Apply outward pressure to disengage lever from rack. Move lever forward or back to adjust height. (Fig. 6 and
see clause 6.4).
Fig. 6
6. OPERATING INSTRUCTIONS
Service the engine with petrol and oil as instructed in the separate engine manual packed in your scarifier.
Read instructions carefully.
WARNING! Petrol is highly flammable.
Store fuel in containers specifically designed for this purpose.
Refuel outdoors only, before starting the engine and do not smoke while refueling or handling fuel.
Never remove the cap of the fuel tank or add petrol while the engine is running or when the engine is hot.
If petrol is spilled, do not attempt to start the engine but move the machine away from the area of spillage and
avoid creating any source of ignition until petrol vapors have dissipated.
Replace all fuel tanks and container caps securely.
Before tipping the scarifier to maintain the blade or drain oil, remove fuel from tank.
WARNING: Never fill fuel tank indoors, with engine running or until the engine has been allowed to cool
for at least 15 minutes after running.
6.1 TO START ENGINE
1. Before starting engine, please turn the engine switch to the “ON” position. (Fig.7A)
3. To start a cold engine, move the Carburetor lever to the “on” position (Fig. 7B). Keep the choke lever stay to
the “off” position (Fig. 7B).
4. Standing behind the unit, grasp the brake control handle (OPC) and hold it against the Lower handle. (Fig.
7C)
5. Keep hold of the brake lever (OPC) as shown Fig.7C and grasp the starter handle as shown Fig 7D pull up
rapidly. Return it slowly to the rope guide bolt after engine starts.
6. Move the choke lever to the “on” position. (Fig.7F)
Note! When the cutter deck is in contact with the ground, the unit can move.
To Next Page
Loading...