Classified - Confidential
▪ Use both ends of the brush and clean the nozzle injector ring vigorously
at an angle. A stabbing motion can be used to remove clogs from the
holes. The blue ring in picture 1 below notes the location of holes. Picture
2 also shows the location of the nozzle injector ring holes for scrubbing.
▪ Soak a clean microfiber cloth in hot water and hold it against the
nozzle injector ring for 10 seconds and squeeze water into the holes
▪ Repeat these steps as often as necessary to loosen clogs
o Re-attach the nozzle tip
1
2
To Next Page
Loading...
