Step 3:Take out the buckle from the cloth cover and store the buckle face down,
according to the picture below (Picture E).
5.9. Removing the Fabric Cover
3. Move the headrest of the child seat up to the highest position.
2. Take off the cover from the backrest and base.
5.8. Removing the triangle pad and the sleeping pad
When your child's weight exceeded 8kg, remove the triangle pad.
When your child's weight exceeded 12kg, remove the sleeping pad.
1. Remove the 5-point harness.
4. First take the cover off the base of the headrest, then remove the cover of the
headrest. To re-fit the cover, simply follow the above steps in reverse.
CAUTION! Never use the child seat without it correctly installed.
CAUTION! Check that the harness straps are not twisted and that they have
been correctly inserted in the belt slots of the cover.
6.1.1 Installed in rearward facing position with safety belt
Then adjust diagonal belt and lap belt as follows:
Note: Once the safety belt of some models is pulled out a certain length, If you
need to increase the length of the pulled-out section you will not be able to do it.
In this case, the seat belt must be fully rolled up and pulled out again to the
required length. Finally, check the safety seat to ensure it is firmly fixed on the
car seat. To make sure that the car seat has been installed correctly, please
shake it before use. If shaking or loosening is found, you must retighten the
safety belt until the safety seat is stable. Warning: the car safety belt must not be
twisted after installation.
6.1.2. Installation in rearward facing position with ISOFIX and Top Tether for
Group 0+I(0-18kg)
Put the ISOFIX insert guide into the two ISOFIX attachment points of your
vehicle. If you don't have ISOFIX insert guide, please ignore this step. This is
not a mandatory step, your product will work just as well without the guides.
6. Installation in the vehicle
The side which can pull out belt: djust the diagonal seat belt section is through
from the between the headrest and the backrest. The side which can insert the
buckle: fasten the seat belt and pull it tight, ensuring that the seat belt is not
twisted.
6.1. Installation in rear-facing position
Rotate the seat to 90 degree first, then use the recline handle to adjust the seat
to the maximum angle. Later fix the seat in the rearward facing position.
Group 0+(0-13kg)
Pull the vehicle seat belt, the diagonal seat belt section is bypassed from the
back of the seat and passes through from the between of the headrest and
backrest, the lap belt section through the belt guidance and under the sleeping
cushion. Ensure that the buckle tongues are properly locked into the vehicle
seat buckle - you will hear an audible CLICK.
EN
To Next Page
Loading...
