3. USE IN THE VEHICLE
Read vehicle handbook about approved ISOFIX positions.
Only suitable for use in the listed vehicles fitted with 3 point/with retractor safety-
belts, approved to ECE Regulation No. 16 or other equivalent standards.
Install in forward seating positions, don’t install in backward or lateral seating
positions.
DO NOT place rear-facing child seat on front seat with active airbag, DEATH OR
SERIOUS INJURY can occur.
DO NOT place rear-facing child seat on front seat with active airbag. Only
suitable when equipped 3 point belts.
4. PREPARATORY WORKS
4.1 Adjusting buckle
Open buckle
Press red button until buckle latches come out from the buckle.(fig.1)
Lock buckle Guide the two buckle latches together (fig.2), putting them into the
harness buckle house (fig.3). Buckle locked when sounds click (fig.4).
Notice: buckle can not lock only by putting one latch.
4.2 Adjusting harness
Tighten harness Pull the adjuster strap until the harness lies flat and is close
against your child‘s body (fig.5).
Notice: Make sure the space between the child and the shoulder harness is
about the thickness of one hand
Loosen harness
Press the center adjuster and at the same time pull both shoulder belts
forwards.(fig.6) Do not pull on the shoulder pads
4.3 Adjusting headrest
Important ! A correctly adjusted headrest ensures optimal protection for your
child in the safety seat.
When installed by 5-point harness, the headrest must be adjusted so that the
shoulder belts are at the same level as your child’s shoulders.(fig.7)
CAUTION! The shoulder belts must not run behind the back of the child or at ear
height or above the ears.
When installed by 3-point vehicle belt, The headrest must be adjusted so that
there is a space two fingers wide between the headrest and your child‘s
shoulders. Make sure the diagonal seat belt section is on child’s shoulder but
not on neck. (fig.8)
EN
To Next Page
Loading...