Each log will be displayed for 30 seconds before “timing-out” and returning to the
Surface Mode. Via the optional Analyst
®
Personal Computer Interface, the Logbook
Mode “time-out” timer can be set from 10 to 60 seconds in one-second increments
which would allow the user to view each dive for more or less time.
It is not necessary to allow the time-out timer to complete prior to initiating a dive. Once
the diver has descended below two metres, the COMMANDER+ will immediately enter
the Subsurface Mode.
METRIC
A
S
C
T
N
E
DEPTHMAXBOTTOM
TEMP
SURF
.
Figure 9
LOGBOOKMODEDISPLA Y
OverallD ive N um b e r 235
MaxDepth 18.9m t
Min Te m p e ra tu re 2 1 c
MaxAscentRate 5mpm
B a tte ry O K
NOTE: The overall Dive Number allows the diver to immediately identify the total
number of dives made with that COMMANDER+. If the logbook example shown was
the most recent dive made, it could be identified that that 235 dives had been made with
that specific unit.
29
To Next Page
Loading...
