TMT-502 REMOTE CONTROL WITH TIMER
Remarks
Reminders
• This product must be used in combination with at least one COCO receiver. The wireless system can
be expanded indefinitely with other COCO remote controls and/or receivers.
• This product is a combination of a remote control and a timer. Remote control: Control one (or more)
COCO receiver(s). Timer: Switch a COCO receiver on and off at the desired time.
• If the product does not work or does not work properly:
- Check the correct placement and/or function of the batteries (replace if necessary).
- Check step for step whether everything is programmed correctly.
- Make sure the set "house code" (see [4]) of this product is the same as on the COCO receiver(s) that
are to be controlled. The numeric code of the receiver(s) must match the channel (“Unit”) on this
product (see [9]).
- Perhaps someone nearby is using the same house code. Set the wireless COCO system to another
letter code combination.
Dimming function
• The dimming function only works if the concerned receiver is suitable for this function. For more details
concerning the dimming function, see the manual for the dimmer receiver.
• The dimming function cannot be pre-programmed with the timer.
• Do not program dimmer receivers and on/off receivers for operation with the same button on the remote
control.
• Do not program multiple dimmer receivers for operation with the same button on the remote control;
use separate buttons.
Safety instructions
• This product is equipped with child protection with which the programming buttons can be locked: Press
the “/DEL” and “ENTER” buttons simultaneously for 3 seconds. “C.P.” (Child Protection) appears on
the screen. Do the same to deactivate the child protection.
• Do not expose this product to excessive heat, direct sunlight or moisture.
13
To Next Page
Loading...
