9. tr o u b l e s h o o t I n g
The AVS58 Audio / Video Sender System you have purchased is built in accordance with
state-of-the-art technology and is safe for operation when used in accordance with the
instructions. However, problems or malfunctions may still occur. The following list denes
possible problems and associated solutions:
9.1 no pI C t U R E o R So U n D
Is the source device(s) (PayTV decoder, DVD Player, etc.) switched on?•
Are the Transmitter and Receiver both supplied with power and switched on (power lights •
should be illuminated)?
Is the source device(s) connected correctly to the Transmitter (see pages 6-9)?•
Is the remote TV connected correctly to the Receiver (see pages 10-11)?•
Areallcablespluggedinrmly?•
Are the source device(s) congured to the correct outputs (the ones the Transmitter is •
connected to – you may need to consult your device manuals)?
Have the Transmitter and Receiver been inadvertently switched? (The Transmitter should be •
connected to the source device(s) and the Receiver in the remote location).
Is your Receiving TV (in the remote location) set to the correct input channel that the Receiver •
is connected to (e.g AV 1 - you may need to consult your TV manual)?
9.2 no So U n D RE p R o D U C t I o n
Is the volume turned up on your source device(s) and receiving TV?•
Isthesourcedevice(s)conguredtooutputsoundontheoutputsconnectedtotheTransmitter •
(you may need to consult your device manuals)?
AretheplugsoftheAVcablesrmlypluggedintheconnectingsocketsofthesourcedevice(s), •
Receiving TV, Transmitter and Receiver?
Are the RCA plugs (Yellow = Video, Red = Right Audio, White = Left Audio) or SCART adapter •
of the AV cables connected to the correct sockets (see pages 6-11).
9.3 In t E R f E R E n C E /DI S t o R t I o n W I t H So U n D A n D /o R pI C t U R E
The range between the Transmitter and Receiver may have been exceeded (if there are solid •
brick or a number of walls between the Transmitter and Receiver this will reduce the range of
the system).
Is there a metallic barrier (e.g. steel reinforced concrete wall) between Transmitter and •
Receiver? If so, try relocating the positions of the Transmitter and/or Receiver.
To Next Page
Loading...