Cocraft HMS 210-L Series - User Manual

ENGLISHSVENSKANORSKSUOMIDEUTSCH
Important!
Read the entire instruction manual
carefully and make sure that you fully
understand it before you use the
equipment. Keep the manual for future
reference.
Viktig information:
Läs hela bruksanvisningen noggrant och
försäkra dig om att du har förstått den
innan du använder utrustningen. Spara
bruksanvisningen för framtida bruk.
Viktig informasjon:
Les disse anvisningene nøye og forsikre
deg om at du forstår dem, før du tar
produktet i bruk. Ta vare på anvisningene
for seinere bruk.
Tärkeää tietoa:
Lue nämä ohjeet huolellisesti ja varmista
että olet ymmärtänyt ne, ennen kuin
alat käyttää laitetta. Säilytä ohjeet
myöhempää tarvetta varten.
Wichtiger Hinweis:
Vor Inbetriebnahme die komplette
Bedienungsanleitung sorgfältig
durchlesen und aufbewahren.
HMS 210-L
STEPLESS 0-45° MITRE ANGLE SETTINGS
1450 W
18-3602 ∙ 41-1072
SLIDING MITRE SAW
KAP- OCH GERINGSSÅG
KAPP- OG GJÆRESAG
KATKAISU- JA JIIRISAHA
KAPP- UND GEHRUNGSSÄGE
Ver. 20180430
Original instructions
Bruksanvisning i original
Originalbruksanvisning
Alkuperäinen käyttöohje
Original Bedienungsanleitung
Art.no Model
18-3602 M1YL-4DF-216JA
41-1072 M1YL-4DF-216JA

Summary

Safety

General Safety Guidelines

Fundamental safety precautions to avoid fire, electrocution, and personal injury.

Mitre Saw Specific Safety Rules

Specific safety guidelines for operating compound mitre saws and inherent hazards.

Safety Symbol Explanations

Explanation of safety symbols used in the manual, including laser and PPE warnings.

Product Overview

Operating Instructions

Cross-cutting

Instructions for performing cross-cuts, including setting the saw blade angle to 0°.

Bevel Cutting (0-45°)

Steps for adjusting and performing bevel cuts at angles between 0 and 45 degrees.

Mitre Cutting (-45°;0°;+45°)

Procedure for setting and performing mitre cuts at various angles, including negative angles.

Sawing Bowed Workpieces

Guidance on how to cut workpieces that are bowed to prevent blade pinching.

Care and Maintenance

General Maintenance Procedures

Procedures for cleaning the saw, ventilation openings, and using mild cleaning agents.

Changing the Saw Blade

Step-by-step guide for safely replacing the saw blade, including safety notes.

Carbon Brush Maintenance

Instructions for checking and replacing motor carbon brushes, including lifespan and replacement criteria.

Responsible Disposal

Specifications

Declaration of Conformity

Cocraft HMS 210-L Series Specifications