Coda 40.0 - Page 11

I. Design Philosophy and Approach (continued)
To maintain “Precision Bias” requires an advanced bias circuit that must have a very
high degree of stability under a wide range of temperatures and load conditions.
Most amplier bias networks are of such high impedance and poor thermal regulation
that at the extremes of operation, bias currents are ineectively controlled. Advanced
tracking techniques used in the 40.0 result in absolute control of bias currents under all
conditions.
The main power supply of the amplier consists of a 3000VA transformer with indepen-
dent rectiers to isolate the channels from one another. 200,000 microfarads of
total capacitance provide eective ltering of all AC ripple.
These attributes result in a amplier of such extreme linearity and bandwidth that no
overall feedback correction is required or used. One advantage of this is a high
degree of immunity from interactions with loads or cables and a superior transient
response. An extremely low nonreactive output impedance is maintained well beyond
20,000 hz. The resulting uniform damping factor is not commonly found in other
designs.
The chassis of the 40.0 is constructed of machined aluminum milled to very close
tolerances yielding the seamless appearance characteristic of previous products
from Coda. As with all high-power ampliers, heat dissipation is important. The 40.0
uses six massive aluminum heat sinks without fans for ecient, noiseless, and clean
thermal relief. The thermal coecient of the 40.0 heat sinks is one of the lowest and
most eective in the audio industry.
DESIGN PHILOSOPHY 10