Code 3 ARROWSTIK AS-10 User Manual (English)

Questions and Answers:

J
Jennifer BryantJul 31, 2025
Why is my Code 3 Automobile Electronics ArrowStik not turning on?
- A
  Anthony NicholsonAug 1, 2025
  If your Code 3 ArrowStik isn't functioning when turned on, several factors could be responsible. It might be due to a loose or disconnected plug in the rear of the control box, so try reconnecting the plug. Another potential cause is a faulty ground (earth) or power connection; therefore, verify both the ground (earth) and +12Vdc connections. Lastly, the control box itself might be damaged. If checking the connections doesn't resolve the issue, further assistance is needed.
B
Bill MoodyAug 8, 2025
What to do if the light output of my Code 3 ARROWSTIK AS-10 Automobile Electronics appears dim?
- D
  David EdwardsAug 8, 2025
  If the light output of your Code 3 device appears dim, there are a few things to check. First, low voltage could be the culprit, so check the connections and battery. Secondly, verify the ground (earth) connections. Lastly, ensure that the product is not in "Dim" Mode; if it is, select the appropriate mode.
M
Michael JordanAug 15, 2025
What to do if some lamps on my Code 3 Automobile Electronics don't light but the LEDs function?
- K
  Kathleen BarnesAug 15, 2025
  If one or more lamps on your Code 3 Automobile Electronics aren't lighting up while the LEDs on the control box are functioning correctly, it could be due to a few reasons. The lamp(s) may have failed, in which case you should replace them. Alternatively, there might be a bad wiring connection, so verify all connections.
E
Emily TurnerAug 23, 2025
What does it mean if LEDs on my Code 3 ARROWSTIK AS-10 control box burn continuously?
- W
  William GonzalesAug 23, 2025
  If the LEDs on your Code 3 Automobile Electronics control box are burning continuously, it indicates that the control box is damaged.