What to do if Code 3 Speaker System has no output, but siren amplifier makes noise?
If your Code 3 Speaker System has no output and the siren amplifier is making noise, it could be due to an open circuit in the speaker wiring. Check the connections at both the amplifier and siren amplifier. Alternatively, the drivers might be defective. Check the resistance across the speaker wires (it should be 3.8 ohms), and replace the drivers if necessary.
Why is the output low from my Code 3 FM100C?
If you are experiencing low output from your Code 3 Speaker System, it could be due to low output voltage from the amplifier. Please refer to the siren amplifier owner's manual for troubleshooting steps. Another potential cause is dual speakers not being connected in phase. Refer to the speaker wiring instructions in the manual to ensure they are correctly wired.
Instructions for cleaning the unit using mild soap and water, avoiding harsh chemicals.
Steps to replace an inoperable speaker driver, including disassembly and reassembly procedures.
Process for returning products for repair or replacement, including obtaining an RGA number.
General| Brand | Code 3 |
|---|---|
| Model | FM100C |
| Category | Speaker System |
| Language | English |
To Next Page