English Manual
- 9 -
Manual operation of scanner
1. Press manual key;
2. Use number key to choose scanner wanted to be controlled manually. Multi scanner can be chosen.
3. Move CH1-CH12 slider to set each channel value of a scanner. Last channel value is displayed on LCD
display. After moving slider to make channel value of the scanner larger than the current channel value,
the scanner can be controlled by the slider.
4. Press manual key again to cancel manual operation of a scanner. The controller can remember the last
channel values displayed on LCD display. When the controller enters into manual operation again, the
last channel values are resumed.
5. In manual operation state of a scanner, press delete key to clear the record of manual operation.
Tips
♦ If multi scanners are chosen, moving channel slider can act on all chosen scanners simultaneously.
♦ When a chase program is running, manual operation can be performed.