Code Gobo 200 - Page 18

English Manual
- 8 -
Schematic of program edit
① Into program edit state
------------------------------------------
Press Program key for more
than 1 second
② Choose program No.
------------------------------------------
Use number key to choose
program No.
③ Choose chase step
------------------------------------------
Use＜＞key to choose chase step.
④ Choose scanner
------------------------------------------
Use number key to choose scanner
⑤ Set channel value
------------------------------------------
Move CH1~CH12 slider to set
channel value of a scanner
Edit another scanner?
YesNo
Edit another chase step?
YesNo
⑧ Quit from program edit state
------------------------------------------
Press Program key more than
1 second.
⑥
⑦