Why is the Colasit Fan output too low?
If the Colasit Fan output is too low, it might be due to a few reasons. First, check the impeller's rotation direction and change it if it's incorrect. High pressure losses in the ducts could also be the cause, consider changing the duct arrangement. Finally, make sure the restrictors are fully open.
What to do if V-belts slip on Colasit Fan?
If the V-belts on your Colasit Fan are slipping, it could be due to incorrect pretension. Check the belt tension and retighten if necessary. Another cause could be foreign bodies or soiling in the grooves or pulleys, so clean the pulleys and check the belt profile.
How to fix a Colasit Fan that is not running smoothly?
If your Colasit Fan is not running smoothly, several factors could be at play. The impeller might be imbalanced, requiring rebalancing by a specialist company. Alternatively, the impeller could be caked up, requiring careful cleaning and rebalancing if necessary. Material corrosion or deformation due to high temperature may also be the cause, in which case you should consult the manufacturer and check bearings. Also, ensure the V-belt drive is correctly aligned, and adjust the belt drive if needed.
What causes a Colasit CMVeco 160 to fail to reach its rated speed?
If the Colasit Fan fails to reach its rated speed, it could be due to incorrectly adjusted electrical switching mechanisms; check the motor protection setting and reset if necessary. Also, the motor winding might be defective, or the drive motor drive not correctly designed, please consult manufacturer to verify starting torque.
Why is there a rise in temperature of roller bearings in my Colasit CMVeco 160 Fan?
A rise in temperature of roller bearings in Colasit Fan can happen if the bearing was not greased. To solve this, change the bearing and grease at regular intervals as stipulated in the maintenance instructions.
What causes a V-belt to be torn or damaged on a Colasit Fan?
If the V-belt on your Colasit Fan is torn or damaged, it might be due to normal wear and tear, in which case you should replace V-belts in sets. Alternatively, the V-belt might be pretensioned too strongly, so tension replacement belt to manufacturer’s specifications.
What to do if there is a leak on sleeves of Colasit CMVeco 160?
If you notice a leak on the sleeves of your Colasit Fan, it could be because the sleeves are defective; replace them. Alternatively, the tensioning straps might not be tight enough, so retighten them.
Why is my Colasit CMVeco 160 making grinding noises when running or starting?
Grinding noises when your Colasit Fan is running or starting can occur if the intake duct is fitted under tension. To resolve this, remove the intake duct and realign it.
General information about the COLASIT fan, including definitions, warranty, and safety.
Recommends operator review of the operational environment after installation.
States only trained and authorized personnel may operate, handle, and maintain the fan.
Describes potential emergencies like component bursting, melting, or fire.
Lists various risks and safety precautions related to operation and maintenance.
Outlines mandatory steps before commissioning, including reading manual and safety inspector approval.
States the fan must be operated according to the manual to avoid damage.
Presents the ATEX declaration of conformity and applicable harmonised standards.
To Next Page
General
