compacta_g - 02_05
6.5 CLEANING OPERATIONS
• Wash all parts in lukewarm water (80-90°F) using a mild non-foaming detergent. Scrub each of
the parts with the cleaning brusheh provided in the machines spare parts kit.
CAUTION
Do not use hot water on plastic parts as damage to the parts can result.
2) Rinse
1) Wash
3) Sanitize
4) Air Dry
6.6 ASSEMBLY OF PARTS
Once the parts have been washed, rinsed and sanitized, the freezer is ready to be re-assembled.
Prior to beginning the re-assembly procedure, sanitize your hands by submerging them in the
sanitizing solution.
• Lubricate all rubber parts with the lubricant included in the Start-Up Kit.
• Reassemble the components in reverse order to the disassembly procedure previously stated.
6.7 SANITIZING THE MACHINE
Prior to filling the machine with fresh liquid mix, the assembled machine must be sanitized. The
frequency of cleaning and sanitizing must comply with your local and/or state health regulations.
If uncertain of these regulations, contact your local Health Departments or Department of Agriculture.
Sanitizing your machine is very important. This procedure will retard the growth of bacteria and
insure excellent product bacteria test results performed by your local inspectors.
To begin, you will need the sanitizer, spatula, large cleaning brush, (all included in the start up kit),
and clean pail.
Mix the sanitizer into a clean pail with at least two gallons of warm water. Mix the sanitizer and water
to make a 200-PPM. concentration of sanitizer solution. Using the spatula, stir the solution until
the sanitizer is completely dissolved.
IMPORTANT
Do not exceed the formula recommended by the sanitizer manufacturer
as it will not add to the sanitizing effectiveness. DO NOT use straight
chlorine bleach since it does not clean properly and will damage plastic
components. Do not leave the sanitizing solution in the machine longer
than one hour as it can corrode some parts.
Using your three-tank sink, wash, rinse and sanitize all of the disassembled machine parts. Mix
the sanitizing solution to a 200ppm concentration with warm water. Allow the parts to soak in
the sanitizing solution for 3-5 minutes before removing. Allow the parts to air-dry on the clean,
sanitized counter at the end of the sink. DO NOT towel or sponge dry these part
To Next Page
Loading...