Coleman 300101 - Assembly and Operating Instructions

9 10
Surface Preparation
Before starting any cleaning task, it is important to inspect the area for objects that
could create a hazard. Remove any objects from the work area that could be tripped
over, such as toys or outdoor furniture. Ensure that all doors and windows are closed
tightly.
When connected directly to garden hose
Only draw water through the unit. For use with cold water supply only. Water hose
must be at least a 1/2” (13 mm) in diameter. Flow rate of water supply must not fall
below 2 US GPM (gallons per minute) [7.6 LPM (litres per minute)] Flow rate can
be determined by running the water for one minute into an empty 5-gallon (19 L)
container. The water supply temperature must not exceed 104°F (40°C).
CAUTION
•Neverusethepressurewashertodrawinwatercontaminatedwithsolvents
(e.g. paint thinners, gasoline, oil, etc.).
•Dirtinthewaterinletwilldamagetheunit.Toavoidthisrisk,werecommendchecking
thewaterlter(locatedinsidethewaterinlet.Tocleanitout,seeMaintenancesection).
•Alwayspreventdebrisfrombeingdrawnintotheunitbyusingacleanwatersource
andanadditionalaccessorywaterlterifrequired.
•Toprolongthelifeoftheunit,resttheunitfor5minutesafterevery
30 minutes of use.
ASSEMBLY AND OPERATING INSTRUCTIONS ASSEMBLY AND OPERATING INSTRUCTIONS
1 2
Attach high pressure hose to the
machine’s water outlet (hand tighten
only)
Attach high-pressure hose to the gun
assembly (hand tighten only)
Insert adjustable wand to the gun and
twist ¼ turn to lock in position.
Attach the inlet adapter to the
machine’s water inlet. Hand tighten
only. Some models come with inlet
adaptor pre-assembled. Check your
unit.
3 4