Coleman MACH 9 - Ceiling Assembly LED Lights and Buttons; Routine Maintenance and Warranty; Routine Maintenance; Warranty Information

xi. LED LIGHTS AND BUTTONS ON THE
CEILING ASSEMBLY.
The ceiling assembly has a two color LED to indicate if
the unit is in Cooling or Heating. Two manual override
buttons - one for cooling the other for heating – can be
used if the remote controller is lost or malfunctions.
xii. ROUTINE MAINTENANCE
One of the biggest advantages to your new Coleman-Mach
heat pump is that the maintenance needed to keep the unit
in good working order is minimal. In fact about the only
thing you, the owner, must take care of is the cleaning and
replacement of the lters.
The ceiling assembly and the outside shroud can
be cleaned with a damp cloth. When required a mild
detergent can be used.
Filters are made from long life non-allergenic natural
bers which can be cleaned and reused, and which
completely lter the circulated air when the heat pump
is in operation. If the lters are not cleaned at regular
intervals, they may become partially clogged with lint,
dirt, grease, etc. A clogged lter will produce a loss of
air volume and may eventually cause an icing-up of the
cooling (evaporator) coil.
IMPORTANT: Do not operate your heat pump for extended
periods of time without the lter installed.
An even more serious condition occurs when the heat pump is
operated without a lter. When this happens the lint, grease, etc.
that are normally stopped by the lter are now accumulating in
the cooling coil. This not only leads to a loss of air volume and
a possible icing-up of the cooling coil, but could also result in
serious damage to the operating components of the heat pump.
Cleaning and/or changing the lters:
1. Remove the two grilles from the ceiling assembly by
pulling the tabs on the grilles as shown in illustration.
2. Remove and clean or replace the two lters. The
lters should be washed in warm water or vacuumed
clean. The lters should be inspected once a month
and cleaned or replaced as required.
3. Re-install the lters and grilles in the ceiling
assembly.
NOTE: If the unit is operated in a dusty environment, the lters
should be inspected and cleaned more frequently.
xii. WARRANTY
For Full WARRANTY Terms and conditions
on products purchased in Australia or New
Zealand, please visit www.coastrv.com.au or
www.coastrv.co.nz
11
INFRARED
RECEIVER
Manual
Override
Buttons for
Heating &
Cooling
TWO color LED
(Red for Heating and
Blue for Cooling)
Tabs to Access Filter
Tabs to Access Filter