Coleman Rechargeable QuickPump 2000000835

To Next Page

To begin inflation, open

external cap and pull firmly

on lanyard to extend out.

This will open internal

yellow seal.

Attach adapter nozzle to

inflation end of

Rechargeable Pump. Insert

pump and turn on.

When fully inflated, seal

valve by pushing in with

pump nozzle. This will seal

the internal yellow stopper

and keep air from escaping

while closing the cap.

Fully remove pump and

close external stopper.

Valve should appear

depressed into itself.

Remove adapter nozzle

from inflation end and

attach to deflation side of

pump. Repeat same steps

as inflation. This will draw

the air out quickly.

Attach pinch valve adapter to inflation end of pump.

Insert pinch valve adapter into pinch valve.

Make sure tip of adapter is extended past inner

“flap” inside of valve.

Turn pump on.

When fully inflated, remove pump from valve and

seal valve.

THINGS YOU SHOULD KNOW

• Carefully follow instructions on articles to be inflated. Never exceed

recommended pressures. Bursting items can cause serious injury.

• Never leave Coleman

Rechargeable Pump unattended while in use.

Note: Pump will not work on stem valves or needle valves

commonly used on bike tires, basketballs, etc.

TO OPERATE:

Remove safety plug from the charging port on rear of the pump.

OPERATION:

• The Coleman Rechargeable Pump needs to be charged for

10 HOURS (but no more than 24 hours) before first use. Charge only

using transformer provided with the pump.

• After use, recharge pump within 48 hours.

• Always store pump with a full charge. To keep the battery at optimum

operating levels recharge the unit every 3-5 months, even if it has

not been used.

• Allow pump to cool off for 20 minutes after every 10 minutes of

continuous operation. Failure to do so may cause damage to the

pump and battery.

• Do not leave pump charging for more than 24 hours to avoid damage

to the battery.

ABOUT THE BATTERY:

This product uses a lead acid, sealed, rechargeable battery. The battery

pack is recyclable. At the end of the battery pack’s useful life, the unit

should be recycled or properly disposed of.

Do not discard in a

landfill or incinerate.

Contact your local city officials for battery

disposal information. If a battery collection program does not exist in

your area, call Coleman toll free at 1-800-835-3278 for battery

disposal information.

OTHER VALVES:

The Coleman Rechargeable Pump is compatible with most valves on

inflatable products. If you have an inflatable product with a pinch valve,

an adapter is included.

Inflating Coleman® Double-Lock™ Valve:

Inflating Standard Pinch Valve:

Deflation

CAUTION: Do not block the air portals during

operation, this could damage the motor.

Need help?

Do you have a question about the Coleman Rechargeable QuickPump 2000000835 and is the answer not in the manual?

Summary

General Information and Safety

Things You Should Know

Important safety and usage guidelines for the pump, including pressure limits and unattended operation.

Battery Information

Details on the lead-acid battery, its recyclability, and proper disposal instructions.

Other Valves Compatibility

Information on pump compatibility with various inflatable valves, including pinch valves.

Safety Caution

Warning against blocking air portals during operation to prevent motor damage.

Pump Operation Procedures

Inflating Coleman Double-Lock Valve

Step-by-step guide for inflating using the Double-Lock valve, including opening the external cap.

Deflation Procedure

Instructions for deflating items, including removing the adapter nozzle and attaching to the deflation side.

Inflating Standard Pinch Valve

Instructions for inflating products with a standard pinch valve using an adapter.