USING THE WATER FLOSSER:
1. Place the nozzle into your mouth before
turning the device on.
2. Align the nozzle against your teeth and
gumline.
3. Work the nozzle along the gumline, paying
special attention to the area between
teeth and around braces.
4. While flossing, open your mouth slightly to
avoid water splashing.
5. Keep the flosser upright during use to
prevent the tube in the tank from restricting
water flow.
6. The water tank should allow for up to
60 seconds of flossing depending on the
mode. Refill water tank as needed to
complete flossing session.
CLEANING INSTRUCTIONS:
A) Nozzle
Wash with water, then dry with a
soft cloth or paper towel. It is
recommended to replace the
nozzle every 6 months. Please
replace if the nozzle tip is
deformed, to avoid misuse
or malfunction.
B) Device
Make sure power is turned
off, detach the charger and
seal the charging port.
Open the cover of the
tank, pour out contents
and then close. Turn on
power to empty out any
remaining contents, then
turn off again. Wipe away
any remaining liquid from
the device.
C) Water Tank
It is recommended to
clean the tank once a
week. To do so, open the water
tank cover then pull the water tank to the
marking line until you hear the “click” sound.
Slightly push both sides of the tank and
remove the water tank case. Clean using
3. The default mode for the water flosser is
Gentle, it is recommended to start on the
Gentle mode and gradually increase
modes if desired.
ADJUSTING THE PRESSURE
SETTINGS:
1. Device turns on in the last mode used.
2. Press the mode button to switch between
pressure settings for your preferred
flossing style:
· Gentle: Low pressure mode
· Regular: Regular pressure mode for daily
cleaning
· Pulse: Pulsation pattern for gum massaging
To Next Page
Loading...
