EasyManua.ls Logo

Colgate blast - Cleaning Instructions; Nozzle Cleaning; Device Cleaning; Water Tank Cleaning

Colgate blast
10 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
USING THE WATER FLOSSER:
1. Place the nozzle into your mouth before
turning the device on.
2. Align the nozzle against your teeth and
gumline.
3. Work the nozzle along the gumline, paying
special attention to the area between
teeth and around braces.
4. While flossing, open your mouth slightly to
avoid water splashing.
5. Keep the flosser upright during use to
prevent the tube in the tank from restricting
water flow.
6. The water tank should allow for up to
60 seconds of flossing depending on the
mode. Refill water tank as needed to
complete flossing session.
CLEANING INSTRUCTIONS:
A) Nozzle
Wash with water, then dry with a
soft cloth or paper towel. It is
recommended to replace the
nozzle every 6 months. Please
replace if the nozzle tip is
deformed, to avoid misuse
or malfunction.
B) Device
Make sure power is turned
off, detach the charger and
seal the charging port.
Open the cover of the
tank, pour out contents
and then close. Turn on
power to empty out any
remaining contents, then
turn off again. Wipe away
any remaining liquid from
the device.
C) Water Tank
It is recommended to
clean the tank once a
week. To do so, open the water
tank cover then pull the water tank to the
marking line until you hear the “click” sound.
Slightly push both sides of the tank and
remove the water tank case. Clean using
warm water and soft cloth or paper towels
and fully dry the device.
D) Tube
This can either be cleaned directly, or it can
be removed completely from the device and
washed using a clean damp cloth and warm
water. To remove completely, take the water
tank apart and gently pull the tube from the
device. After cleaning, reinstall the tube into
the device and wipe dry with a soft cloth or
paper towel. Please do not bend the tube or
it may result in the device malfunctioning.
STORAGE INSTRUCTIONS
AND DEVICE MAINTENANCE:
Ensure this device is empty, dried and stored
without water after each use.
Place in dry area with no direct exposure to
sunlight.
If you plan to stop using the water flosser for
an extended period, we recommend that
you fully charge the battery, clean the flosser
device and nozzles, and store them in a cool
dark place. If you start using your flosser
again, after more than 3 months of non-use,
fully charge the device before use.
This product comes with a warranty against
defects for 2 years from the date of purchase
within AU or NZ.
Retain purchase receipt for product warranty.
For more information contact:
A
B
D
C

Related product manuals