Colorful B365M-PLUS V21 - Page 54

SATA And RST Configuration (SATA settings)

SATA Controller (S)
Open or close the SATA controller. Options: Enabled, Disabled.
 SATA Mode Selection
Set up the SATA controller working mode. Options AHCI.
 SATA Controller Speed
Set the speed of the SATA controller. Options: Default, Gen1,
Gen2, Gen3.
 SATA Port
This option displays the connection status of the SATA
.
ACPI Settings (advanced configuration of ACPI)

Enable ACPI Auto Configuration
Set the ACPI auto configuration. If you open this option, ACPI
will open all supported sleep modes. If you close this option, you
will play the following options.
 Enable Hibernation
Opening or closing the operating system's sleep function. This
option is only valid for a part of the operating system.
These Lock legacy Resources
 ACPI Sleep State
Select the standby mode under OS. Options: Suspend Disabled,
S3 (Suspend to RAM).
 RTC Wake
Set up the system wake-up. Options: Disabled, Fixed Time
(timing), Dynamic Time (dynamic time). When the "Fixed Time"
is selected, the setting of the specific wake-up time will be
popped. In the format of hours / minutes / seconds. The
reasonable scope of each project is: Hour/ (0-23), Minute/ (0-59),
Second/ sec (0-59).
 State After G3
Set up power-on automatic boot-up.Options: Always On
󽘘Automatic boot-up state󽘙,Always Off󽘘Shutdown state󽘙
痲簊 B365M-PLUS V21/BATTLE-AX B365M-PLUS V21
48