CHANGING FILTERS
Filters should be changed after every remediation job and whenever the lter change indicator light
comes on. The unit should also be cleaned after each job to prevent cross-contamination.
Make sure the unit is dry before installing clean lters.
To change lters:
1) Unplug the Air Scrubber
2) Open door by releasing sliding latches outward, away from the air scrubber body.
3) Remove used lters and install new lters.
4) Latch door closed and plug the unit in a grounded outlet before operating.
AF500 SPECIFICATIONS
Fan Speed: 500-2400 rpm
Certications: ETL, CE, SSA
Motor Rating: .33 hp
Power: 115 Volts, 60 Hz
Current: 2.5 amps
CFM: 250-500
Specications are subject to change without notice.
WARNING: CONTAMINATION HAZARD
Always wear NIOSH compliant protective gear when changing lters and dispose of used lters
according to your local regulations.
To Next Page
Loading...
